Pid Programming; Programming The Temperature Setting - Profitec Go Bedienungsanleitung

6.4 PID programming

The various programming options for the PID control are explained below.

6.4.1 Programming the temperature setting

During operation, the actual temperature of the boiler is displayed. The factory default is programmed to
93°C for coffee and 130°C for steam. Designation: t1 = coffee, St = steam
To adjust the temperature of the coffee boiler, please proceed as follows:
1. Switch on the device so that the boiler is activated. The
temperature of the boiler does not matter for programming. The
heater is off during the programming procedure.
2. Press + and - simultaneously until "t1" (coffee) appears on the
display.
3. Press + to enter the submenu of "t1" to adjust the temperature.
The currently set temperature is shown.
4. Press quickly
5. Wait briefly after adjusting temperature, "t1" will appear.
6. Press - so that "St" (steam) is displayed. (steam) is displayed.
If you only want to change "St" and leave "t1" unchanged, press -
after point 2 to skip "t1" and go directly to "St".
7. Press + to enter the submenu of "St" to adjust the temperature.
The currently programmed temperature will be shown.
8. Press quickly
Translation of the original German user manual
– to reduce or
+ to increase the temperature
– to reduce or
+ to increase the temperature.
ENGLISH
27