Scan Monitor
Radiated RF
3 V/m
IEC 61000-4-3
80 MHz to 2.5 GHz
Electrostatic
Contact: ± 8kV
discharge (ESD)
Air: ±2kV, ±4kV, ± 8kV,
IEC 61000-4-2
±15kV
Electrical fast
2 kV for power supply
transient/ burst
lines
IEC 61000-4-4
1 kV for input/output
lines
Surge IEC
1 kV differential mode
61000-4-5
2 kV common mode
Voltage dips,
-5% UT (95% dip in UT)
short
for 0.5 cycles, -40% UT
interruptions
(60% dip in UT) for 5
and voltage
cycles, -70% UT (30%
variations on
dip in UT) for 25 cycles,
power supply
-5% UT (95% dip in UT)
input lines IEC
for 5 sec
61000-4-11
Power
30 A/m
frequency (50/
50 Hz or 60 Hz
60Hz) magnetic
field IEC
61000-4-8
7. TROUBLESHOOTING
If you experience difficulties in operating your Scan Monitor, refer to the troubleshooting guide
below.
7.1 Troubleshooting for ECG measurements
Problem 7.1.1: I cannot get the Scan Monitor to take an ECG reading.
Rev. 1.7 - Sep 12, 2023
N/A
Portable and mobile RF
communications equipment
should be used no closer to any
part of the equipment or system
including cables than the
recommended separation
distance calculated from the
equation applicable to the
frequency of the transmitter.
Interference may occur in the
vicinity of equipment marked with
the following symbol.
Contact: ±
Floors should be wood, concrete
8kV
or ceramic tile. If floors are
Air: ±2kV,
covered with synthetic material,
±4kV, ±
the relative humidity should be at
8kV, ±15kV
least 30%
N/A
Mains power quality should be
that of a typical commercial or
hospital environment
N/A
A mains power quality should be
that of a typical commercial or
hospital environment
N/A
Mains power quality should be
that of a typical commercial or
hospital environment. If the user
of the equipment or system
requires continued operation
during power main interruptions, it
is recommended that the
equipment or system be powered
from an interruptible power supply
or a battery.
30 A/m
Power frequency magnetic field
50 Hz and
should be at levels characteristic
60Hz
of a typical location in a typical
commercial or hospital
environment