Endress+Hauser RIA452 Betriebsanleitung Seite 79

RIA452
Function (menu item)
Ref. num.
Display sw.
Ref. bargraf
Dec. point
Bar 0%
Bar 100%
Bar rise
Endress+Hauser
6.3.2 Display - DISPLAY/M2
All the settings for the device display are grouped under this menu item.
Parameter setting
Input
Lin.table
Total (*)
Inp.+Lint.
Inp.+Tot. (*)
Lint.+Tot. (*)
In+Lin+Tot (*)
Batch (*)
0 to 99 sec
0
Input
Lintab
XXXXX
XXXX.X
XXX.XX
XX.XXX
X.XXXX
-99999..99999
0.0
-99999..99999
100.0
Right
Left
Description
For choosing the display value on the display.
(If a combination is selected, e.g. "Inp.+Lint", the display alternates between the
selected display values, e.g. measured value (Inp.) and linearized measured value
(Lint.))
• Input = measured value
• Lin. table = linearized measured value
• Total = integrated value
• Inp.+Lint. = alternates between measured value and linearized measured
value
• Inp.+Tot. = alternates between measured value and integrated value
• Lint.+Tot. = alternates between linearized measured value and integrated
value
• In+Lin+Tot = measured value, linearized measured value or integrated value
• Batch = preset counter
Settings marked with an asterisk (*) are only available if the pulse output or inte-
gration option is available and has been configured
Selectable period for displaying the individual values if combinations of display
values have been selected under Ref. num.
This setting is only available if the pulse output or integration option is available
and has been configured
Selects the signal source for the bar graph
Number of digits after the decimal point for bar graph scaling.
Start value for the bar graph
End value for the bar graph
Bar graph orientation.
• Right = 100% value (rising from left to right)
• Left = 100% value left (falling from left to right)
Commissioning
79