Local Operation - Endress+Hauser RIA452 Betriebsanleitung

Operation
Range
Input current is < lower error limit Display
Input current above lower error
limit and below lower limitations
of validity
Input current in valid range
Input current below upper error
limit and above upper limitations
of validity
Input current above upper error
limit
!
74
5.2.1 Display
Display
Fault condition
" "
Display Normal limit value behav-
" " ior
Display scaled measured Normal limit value behav-
value ior
Display Normal limit value behav-
" " ior
Display Fault condition
" "
Relay display
No power to relay: no display
Power to relay: (symbol lit)
Digital input status display
Digital input configured:
Signal at digital input:
Note!
Information on troubleshooting can be found in Sections 9.1 and 9.2 of these Operating Instruc-
tions.
5. 3

Local operation

Operating menu activated by pressing the jog/shuttle dial for 3 seconds at least.
5.3.1 Operation via the jog/shuttle dial
A) E+H 3-key function
Fig. 10: Operation via jog/shuttle dial
Relay Analog output
Set failsafe mode
Normal behavior with max.
10% overrange. No output
< 0 mA/0 V possible
Normal behavior with max.
10% overrange. No output
< 0 mA/0 V possible
Normal behavior with max.
10% overrange. No output
< 0 mA possible.
Set failsafe mode
(green)
(yellow)
• Press = "Enter"
• Rotate in clockwise direction = "+"
• Rotate in counterclockwise direction = "-"
RIA452
Integration
No integration
Normal behavior (negative
integration not possible)
Normal behavior (negative
integration not possible)
Normal behavior (negative
integration not possible)
No integration
Endress+Hauser