DAZE Duo T Installationsanleitung Seite 8

EN
03.2 - Light icons
Icons Status
1
Internet
connectivity
2
Vehicle
3
Energy
management
4
Charger lock
5
Scheduled
programming
6
Self-consumption
04 - Safety information
Read these instructions carefully before using Duo.
All installation, maintenance, and decommissioning operations of Duo must be carried out exclusively by
qualified personnel (qualified electrician).
Disconnect the electrical power by switching off the upstream circuit breaker before performing any cleaning
operations on Duo.
Do not attempt to touch the connector or charging socket contacts, and do not insert any objects into them.
Modifying the components of Duo is not allowed. Do not remove any labels, codes, or nameplates.
Children or individuals who may not be able to assess the risks associated with using Duo should not use the
device, as they may incur serious injuries.
Incorrect installation or repair can pose risks to the user. If Duo is damaged, it must be immediately replaced
by qualified personnel. In case of damage or malfunction, contact technical support by opening a ticket on the
website or through the "Support" section in the Daze app.
The manufacturer cannot be held responsible for any damage to persons or property if the conditions described
in this manual are not followed.
Cables, sockets, and plugs used for the vehicle connection must comply with the safety requirements of the
legislation in force in the country where the equipment is installed. The use of adapters and additional extension
cords for the connection between the EV and EVSE is prohibited.
8.
Description
Blinking: Device not connected
On: Device connected
Off: Connection not configured
On: Cable connected to the vehicle
Off: Cable disconnected from the vehicle
On: Power Manager configured
Off: Power Manager not configured
Blinking: Insufficient network power
On: Locked (including scheduled time)
Off: Unlocked
On: Enabled
Off: Disabled
On: Self-consumption activated
Off: Self-consumption disabled
Load Balancing
Blinking: Device not connected
On: Device connected
Off: Connection not configured
On: Cable connected to the vehicle
Off: Cable disconnected from the vehicle
Off: Slave not connected to the master
On: Slave connected to the master
Blinking: Insufficient network power
On: Default state (only on master)
On: Locked (including scheduled time)
Off: Unlocked
On: Enabled
Off: Disabled
On: Self-consumption activated
(only on master)
Off: Self-consumption disabled
(only on master)
Off: Default state (only on slave)