Fitting The Compressor Housing - Elmo Rietschle 2Bh20360-1 Instandsetzungsanleitung

9 Mounting
610.44495.40.310 · 09.2013
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
9.4

Fitting the compressor housing

▪ Apply grease to the new radial shaft seal ring (096) and the seat of the radial
shaft seal ring in the compressor housing (002) .
In the case of a radial shaft seal ring (096-A) with one lip, fill it 100% with
grease.
OR
in the case of a radial shaft seal ring (096-B) with two lips, fill it approx. 67 %
with grease.
▪ Apply grease to the entire surface of the sealing lip of the radial shaft seal ring
(096) using a brush.
▪ NOTICE! Note the installation position of the radial shaft seal ring (096)!
▪ Insert the radial shaft seal (096) into the compressor housing (002).
▪ In the case of a radial shaft seal ring with two lips (096 -B), degrease the seal-
ing points in the compressor housing (002).
▪ Secure the radial shaft seal ring with two lips (096 -B) using sealant Elastosil
A07.
▪ NOTICE! Note the position of the motor housing (001) with respect to the
compressor housing (002).
▪ Place the compressor housing (002) onto the intermediate flange (026).
▪ Align the holes of the compressor housing (002) and intermediate flange (026).
▪ Put the washers (024) onto the screws (025).
▪ Put medium strength threadlocker onto the thread of the screw (025).
▪ Screw the compressor housing (002) and the intermediate flange (026) to-
gether with screws (025) washers (128) and nuts (028).
38 / 60
Tel. 071 918 60 60, Mail: v-g@prematic.ch
© Gardner Denver Deutschland GmbH