Fitting The Compressor Cover - Elmo Rietschle 2Bh20360-1 Instandsetzungsanleitung

© Gardner Denver Deutschland GmbH
Prematic AG, Märwilerstrasse 43, 9556 Affeltrangen www.prematic.ch
9.7

Fitting the compressor cover

▪ Fill the cavity of the bearing mount in the compressor cover (030) with grease,
according to the following table.
Motor size
2BH20360-1
2BH20540-1
2BH20780-1
▪ Turn the locating pin (X) into the bearing cover (010) and mount the compres-
sor cover (030) on the locating pin.
NOTICE! Note the position of the compressor cover (030) with respect to
the compressor housing (002).
▪ Screw the compressor cover (030) to the compressor housing (002) using the
screws (074).
▪ Screw the bearing cover (010) and compressor cover (030) using the screw
(014).
Remove the locating pin (X) before fitting the last screw.
[g]
21.6 – 25.0
26.3 – 30.4
56.2 – 64.8
41 / 60
Tel. 071 918 60 60, Mail: v-g@prematic.ch
Mounting 9
[oz]
0.726 – 0.881
0.927 – 1.072
1.983 – 2.285
09.2013 · 610.44495.40.310