Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8.4
Inserting/removing the battery (15)
into/from the battery mount (8)
(Fig. 4)
CAUTION
Danger of injury!
Do not insert the battery until the battery-powered tool
is ready for use.
Inserting the battery
1. Push the battery (15) into the battery mount (8). The
battery (15) clicks into place audibly.
Removing the battery
1. Press the unlock button (16) of the battery (15) and
remove it from the battery mount (8).
9
Operation
ATTENTION
Always make sure the product is fully assembled
before commissioning!
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V IXES series and may on-
ly be operated with batteries of this series. Batteries
may only be charged with battery chargers of this se-
ries. Observe the manufacturer's instructions.
DANGER
Danger of injury!
If the product is jammed, do not try to pull the product
out by using force.
–
Switch off the engine.
–
Use a lever arm or wedge to get the product free.
9.1
Hold and guide product
WARNING
Danger of injury due to kickback!
–
Never use the product one-handed!
WARNING
Danger of injury!
–
Never use the product without the front hand guard!
26 | GB
9.1.1
• The front hand guard (1) and the rear hand guard (10)
protect the fingers from injuries caused by contact
with the saw chain (11) if it breaks due to overloading.
• The rear hand guard (10) also protects the hand from
branches and twigs.
• Before each start-up, check the functionality of the
front handle guard (1). Keep front and rear hand
guard (1, 10) clean to ensure proper functioning.
9.2
Switching the product on/off and
operating it (Fig. 1, 5, 6)
Switching on
1. Pull the blade and chain guard (17) off the chainsaw
guide bar (12).
2. Hold the front handle (4) with your right hand and the
rear handle (7) with your left hand. Thumb and fingers
must firmly grasp the handles (4, 7).
3. Bring your body and arms into a position in which you
can absorb the kickback forces.
4. Press the switch-on lock (5) on the front handle (4)
with your thumb.
5. Press and hold the switch lock (5).
6. To switch on the product, push the on/off switch (6).
7. Release the switch lock (5).
Note:
It is not necessary to keep the switch lock pressed after
starting the product. The switch lock is intended to pre-
vent accidental starting of the product.
Switching off
1. To switch it off, simply release the on/off switch (6).
2. Put on the supplied guide bar and chain guard (17) af-
ter each instance of working with the product.
10 Working instructions
Notes:
Before switching on, make sure that the product does not
touch any objects.
• Avoid abnormal postures. Keep proper footing and
balance at all times. This enables better control of the
power tool in unexpected situations.
• You have better control when you saw with the under-
side of the bar (with a pulling chain).
• The saw chain must not touch the ground or any other
object during or after sawing.
• Ensure that the saw chain does not become jammed
in the saw cut. The branch must not break or splinter.
• Also observe the precautions against kick-back (see
safety instructions).
• Always stand above the branch when sawing on
slopes. Ensure that the saw chain does not come into
contact with the ground. After completing the cut, wait
for the saw chain to stop before removing the product.
www.scheppach.com
Front and rear hand guards (1, 10)
(Fig. 1)
Werbung
