Parkside Performance PHDP 180 C2 Originalbetriebsanleitung Seite 43

Replacing the batteries
Replace the batteries if the LC display
(15) is not displaying anything.
Power tools required
• Phillips screwdriver (not included)
Replacing the batteries
1. Remove the screw from the bat-
tery compartment cover (16).
2. Remove the cover of the battery
compartment.
3. Replace the batteries (35) in the
battery compartment with new
batteries. Pay attention to the cor-
rect polarity when inserting the
batteries in the battery compart-
ment.
4. Press the switch lever (17) on the
trigger gun (1).
The LC display shows the selected
pressure. If the LC display is not
displaying anything, check wheth-
er the batteries are inserted cor-
rectly.
5. Insert the cover of the battery
compartment.
6. Fasten the cover of the battery
compartment using the screw.
Maintenance
The device is maintenance free.
Storage
Notes
Always store the device and ac-
cessories:
• clean
• dry
• protected against dust
• protected against frost
• out of the reach of children
Preparing the device for storage
NOTICE! The pressure washer and
accessories will be destroyed by frost
if they are not completely emptied of
water.
1. Completely empty the water from
the device.
• Disconnect the device from the
water supply.
• Turn on the pressure washer
with the On/Off switch (32) for a
maximum of 1 minute.
• Press the switch lever (17) on
the trigger gun (1) until there is
no more water coming out of
the trigger gun (1) or the attach-
ments.
• Turn off the device.
2. Completely empty the water from
the accessories.
3. Store all attachments upright in the
holders with the connection facing
downwards.
4. Roll the high-pressure hose
around the hose reel (5).
5. Store the mains connection cable
in the holder (11) provided.
GB MT
43