Parkside Performance PHDP 180 C2 Originalbetriebsanleitung Seite 35

Do not direct the jet at
•
yourself or others to
clean clothing or shoes.
If you come into con-
•
tact with cleaning agents,
rinse them with sufficient
clean water.
Never use the power cord
•
to pull the plug out of
the outlet or to pull the
device. Protect the power
cord from heat, oil and
sharp edges.
Explosion hazard – do
•
not spray flammable li-
quids.
Do not use the device
•
near flammable liquids
or gases. There is a risk
of fire or explosion if this
advice is not heeded.
Never transport the
•
device while the drive is
running.
Switch off the device and
•
disconnect the plug from
the power outlet. Make
sure that all moving parts
have come to a complete
stop
when leaving the
•
device,
before changing the ac-
•
cessories,
before removing ob-
•
structions or loosening
blockages,
before checking the
•
device, cleaning it or
performing mainten-
ance work on it.
If the device starts to
•
vibrate abnormally, an
immediate check is re-
quired, :
search for signs of
•
damage,
replace damaged parts,
•
contact the service
•
centre.
Cleaning, maintenance
and storage
Allow the motor to cool
•
down before storing the
device for a longer peri-
od.
Replace worn or dam-
•
aged parts in the in-
terests of safety. Use only
original spare parts and
accessories. Using ex-
ternally produced parts
results in the immedi-
ate loss of any warranty
claim.
The device may only be
•
opened by an authorised
electrician. Always con-
GB MT
35