Parkside Performance PHDP 180 C2 Originalbetriebsanleitung Seite 41

Switching on
WARNING! A leaky water system
can result in electric shock! Move
the On/Off switch (32) to the position
"0" (OFF). Pull out the plug. Try con-
necting the water again (see Estab-
lishing a water supply, p. 38).
WARNING! The device may only
be used in an upright position! There
is a risk of an electric shock if the
device falls over. Move the On/Off
switch (32) to the position "0" (OFF).
Pull out the plug. Only now may you
bring the device into the upright posi-
tion. For your own safety, wait about
five minutes until you restore the elec-
trical connection.
WARNING! Unsuitable extension
cables can be dangerous! Use only
extension cables that are designed
for outdoor use. The connection must
be dry and routed above the ground.
We recommend using a cable drum
that holds the socket at least 60 mm
above the ground.
1. Ensure that the On/Off switch (32)
is in the "0" (OFF) position.
2. Put the device in an upright posi-
tion.
3. Insert the mains plug into an
earthed socket with residual cur-
rent circuitry.
The right part of the holder for the
mains connection cable (11) as
seen from behind is rotatable. This
allows you to easily remove the
mains connection cable (10).
4. NOTICE! Dry running will dam-
age the device. Do not operate
the pressure washer with the tap
turned off.
Turn the tap on fully.
5. Move the On/Off switch (32) to the
position "I" (ON).
The motor switches on briefly un-
til the necessary pressure has built
up. The motor then stops.
6. WARNING! Be aware of the re-
coil force when the water jet com-
mences. There is a risk of injuring
yourself or other people. Ensure
that your footing is secure. Keep a
good hold on the trigger gun (1).
Press the switch lever (17) on the
trigger gun (1).
The nozzle starts working at pres-
sure and the motor starts. If you
release the switch lever (17), the
motor stops. The high pressure is
maintained in the system.
Interrupting the operation
You can insert the trigger gun (1) with
lance and nozzle into the holder (31)
for the trigger gun.
1. Release the switch lever (17) on
the trigger gun (1).
2. If you put down the trigger gun:
Lock the switch lever using the
child safety lock (18) (seen from
behind).
⭠ The switch lever is locked ὑ.
⭢ You can pull the switch lever
ὑ.
WARNING! Risk of injury due to
pressure jet! Lock the switch lever
every time you take a break.
3. When taking longer breaks: Move
the On/Off switch (32) to the posi-
tion "0" (OFF).
Bleeding
Bleeding the supply hose
1. Close the tap.
2. Remove the supply hose from the
device.
3. For more, see Establishing a water
supply, p. 38
GB MT
41