Declaration Of Conformity - Control Techniques Commander SE Betriebsanleitung

Control Techniques plc
The Gro
Newtown
Powys
UK
SY16 3BE
SE11200025 SE11200037
SE2D200075 SE2D200110
SE23200400
SE23400150 SE23400220
SE33200550 SE33400550
SE43401100 SE43401500
The variable speed drive products listed above,
AC
have been designed and manufactured in accordance
with the following European harmonised, national and
international standards:
EN60249 Base materials for printed circuits
IEC326-1 Printed boards: general information for the
specification writer
IEC326-5 Printed boards: specification for single- and
double-sided printed boards with plated-through
holes
IEC326-6 Printed boards: specification for multilayer
printed boards
IEC664-1 Insulation co-ordination for equipment within
low-voltage systems: principles, requirements
and tests
EN60529 Degrees of protection provided by enclosures
(IP code)
UL94 Flammability rating of plastic materials
UL508C Standard for power conversion equipment
* Generic emission standard for the residential,
EN50081-1
commercial and light industrial environment
EN50081-2 Generic emission standard for the industrial
environment
EN50082-2 Generic immunity standard for the industrial
environment
EN61800-3 Adjustable speed electrical power drive
systems – Part 3: EMC product standard
including specific test methods
*Applies to Size 1 units only.
EF

Declaration of Conformity

SE11200055 SE11200075
SE2D200150 SE2D200220
SE23400075 SE23400110
SE23400300 SE23400400
SE33200750 SE33400750
These products comply with the Low Voltage
Directive 73/23/EEC, the Electromagnetic
Compatibility (EMC) Directive 89/336/EEC and the
CE Marking Directive 93/68/EEC.
W. Drury
Executive VP Technology
Newtown
Date: 8 March 2000
These electronic Drive products are
intended to be used with appropriate
motors, controllers, electrical
protection components and other
equipment to form complete end
products or systems. Compliance
with safety and EMC regulations
depends upon installing and
configuring Drives correctly,
including using the specified input
filters. The Drives must be installed
only by professional assemblers who
are familiar with requirements for
safety and EMC. The assembler is
responsible for ensuring that the end
product or system complies with all
the relevant laws in the country where
it is to be used. Refer to the User
Guide. A Commander SE EMC Data
Sheet is also available giving detailed
EMC information.