Profitec PRO 600 Bedienungsanleitung Seite 37

Problem
Portafilter/ brew group is
dripping.
"CLn" is shown on the display.
There is a dot on the display.
No Steam
The Machine is cold qickly
Little or no crema on the top of
the coffee
Sparse coffee dispensing, only
drop by drop
Weak "body"
Foam instead of crema
If the machine will not to be used for a long period of time, it is recommended to
.. clean the brew group (see instructions in chapter 7.2). Afterwards, please do not clamp the portafilter
back into the group.
..to empty the steam boiler. Turn the switch of the operational machine to position off. Open the hot water
valve and the boiler water is now discharged by the remaining pressure through the hot water release.
Close the hot water valve after the water has been released. The coffee boiler is emptied out via the brew
group. Activate the brew group lever and release the water into the drip tray. Please make sure some
water remains in the coffee boiler. Start-up of the machine is the same as initial startup (item 5.1).
How to froth
•
If possible, use cold, fresh milk with a fat content of approx. 1.5 % or 3 %. Even homogenized milk is
suitable - if you prefer.
•
Use a pitcher (made of metal) with a minimum volume of 0.5 litres. The diameter of the pitcher should
not be too wide. A narrow and high container is perfect.
•
Open the steam valve for approx. 5 seconds to release the condensation water and to create dry
steam.
Translation of the original German user manual
Possible Cause
Portafilter is not fixed properly.
Group gasket is broken.
The cleaning mode is
programmed
The display is switched off.
The Steamboiler ist switches off
The Eco-Mode is ON
The grind is not fine enough
The coffee is too old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The grind is too fine.
There is too much ground
coffee.
The grind is not fine enough.
The coffee is old.
The amount of ground coffee is
not enough.
The shower screen is dirty.
The beans are improper.
The setting of the coffee grinder
is not suited for the coffee
beans in use.
Troubleshooting
Fix the portafilter properly.
Change group gasket and
shower screen.
Clean the brew group. After
having operated the brew lever
10 times, the "CLn" will
disappear.
+
Press to turn it on.
Go in to the PID-Menu and set
the steamboiler ON
Turn the Eco-Mode in the PID-
Menu OFF ore set the switch off
countdown longer
Use a finer grind.
Tamp the ground coffee more
firmly.
Reduce the brewing pressure.
Use fresh coffee
Use the right coffee amount:
Approx. 7 g – 9 g of coffee for
each cup.
Clean the brew group.
Set a coarser grind.
Tamp ground coffee only
slightly. Increase the brewing-
pressure.
Use approx. 7 g – 9 g of coffee
for every cup.
Set a finer grind..
Use fresh coffee.
Use approx. 7 g – 9 g of coffee
for each cup.
Clean the shower screen.
Use another type of coffee bean.
Adjust the coffee grinder (When
changing the coffee beans,
changing the grind may also be
necessary.)
ENGLISH
36