Dispensing Of Hot Water; Dispensing Of Steam - Profitec Pro 600 Bedienungsanleitung

The remaining pressure/water will be discharged into the drip tray by the lower part of the brew groupe
cylinder.
Caution!
If the group lever is not moved into the lower position properly, hot water and grounds will
squirt out of the brew group while taking out the portafilter. This may cause injuries.
Only freshly ground coffee allows for an optimal coffee result. Therefore, use a
professional coffee grinder. In our assortment you will find several professional and
compact coffee grinders.
We recommend to use a stainless steel tamper with a diameter of 58 mm for optimum
tamping.

6.5 Dispensing of hot water

1. To dispense hot water the steam boiler has to be switched on. Set the steamboiler"ON" in the PID-
display. Please wait until the desired steam temperature has been reached.
2. Place a suitable vessel (with heat-insulated grip) underneath the hot water wand. Now you can
dispense hot water (e.g. for tea). When dispensing large amounts of water, it is advisable to turn the
machine off so that no cold water is pumped anymore.
3. After having dispensed hot water, turn the machine back on. The boiler is automatically refilled with
fresh water.
When the machine is switched off, more hot water can be dispensed.
However, one does not necessarily have to switch off the machine for dispensing hot
water.
Risk of injury
Always keep the hot water nozzle underneath the surface of the water while heating in
order to avoid splashing.

6.6 Dispensing of steam

The PRO 600 makes it possible to generate large amounts of steam in order to heat or froth beverages, e.
g. milk or punch. It is a professional and compact espresso coffee machine with an enormous steam
volume. Therefore, within a few seconds, you can prepare milk froth. Please pay attention to the
instructions below. Do not bring the milk to a boil, otherwise frothing milk will not be possible.
1. To dispense steam the steam boiler has to be switched on. Set the steamboiler "ON" in the PID-
display (more Information in Chapter 6.2.2). Please wait until the desired steam temperature has been
reached.
2. Important: In order to get the best results when frothing milk, open the steam valve for approx. 5.
seconds to release the condensation water in the pipe. This also prevents milk from getting into the
boiler.
3. Immerse the steam nozzle (at the end of the steam dispenser) into the liquid.
4. Re-open the steam handle.
5. Heat and/or froth the liquid.
6. After frothing or heating, release some steam to keep the holes of the steam nozzle clean.
Risk of injury
Always keep the steam nozzle underneath the surface of the liquid while heating or
frothing in order to avoid splashing.
Avoid skin contact with the steam dispenser while cleaning!
Important
After every application, clean the steam nozzle and the steam dispenser with a non-
abrasive, damp cloth; This removes possible liquid residues.
Translation of the original German user manual
ENGLISH
31