Programming The Temperature Mode "O; Programming The Cln Group Cleaning Mode; Programming The Eco Mode - Profitec Pro 600 Bedienungsanleitung

5. Now you can set the boiler on or off by pressing
6. In order to leave the programming mode, wait a short time and the
menu will be left automatically. The steam boiler setting has been
saved. When the steam boiler has been switched off, the PID display
shows only the coffee boiler temperature. When the steam boiler is
switched on, the PID display shows the steam boiler temperature
and the coffee boiler temperature alternately.
6.3.3

Programming the Temperature Mode "o"

You can also set whether the temperature values of t1 and t2 should be displayed in °C or °F.
To adjust this setting, proceed as follows:
+ –
1. Press and at the same time and "t1" will appear on the display.
–
2. Press the button
+
Press to enter the menu.
3. Now you can choose between C for Celsius and F for Fahrenheit by
–
pressing . This will also set t2.
4. Wait a short time and you will exit the menu automatically.
6.3.4

Programming the CLN group cleaning mode

With the PRO 600 you have the option to program a reminder for next the group cleaning at the PID
display. The machine is set to 0 at the time of delivery, so no reminder is programmed yet.
Please take the following steps to program the cleaning reminder:
+ –
Press and at the same time and "t1" will appear on the display. Press
–
the button until you reach "CLn". Press
Now you can carry out the programming in steps of 10 (0-200) by pressing
+
–
and . In order to leave the programming mode, wait until "CLn"
appears and then press the
For example, if you have programmed 90, then you will be prompted with
a "CLn" on the display to clean the brew group after 90 brewing cycles.
Clean the brew group in such a manner that the brew group is flushed
with at least 10 brewing cycles until the temperature indication re-
appears on the display (see 7.2 Brew group cleaning, page 28).
We recommend a cleaning of the brew group after about 90 to 140 brewing cycles. As a
brew cycle only a brew over 15 seconds is counted.
6.3.5

Programming the ECO mode

The ECO mode gives you the opportunity to set an automatic switch off after a preset time.
The factory setting is 90 min. The Eco mode activates a countdown after the last brewing operation, which
will be running in the background and switches the machine off after 90 minutes.
To reactivate the Machine, move the brew lever into the upper position and the Machine will heat-up
again. You can also switch the main switch Off and On again.
To program the ECO Mode, proceed as follows:
Translation of the original German user manual
until "o" appears on the display.
+
to enter the CLN menu.
–
button.
+
.
ENGLISH
29