Troubleshooting - Profitec Pro 600 Bedienungsanleitung

The product complies with the following EU Directives:
•
Low Voltage Directive: 2014/35/EU
•
Directive for electromagnetic compatibility (EMC): 2014/30/EU
•
Directive on the restriction of the use of certain hazardous substances in electrical and electronic
equipment (ROHS): 2011/65/EU
•
Directive 2012/19/EU regarding waste electrical and electronic equipment (WEEE Reg.–Nr.:
DE97592029)
•
Ecodesign Directive 2009/125/EG (ENER 25)
Furthermore, the following regulations were followed:
•
Regulation (EC) No. 1907/2006/EU on the Registration, Evaluation, Authorization and Restriction
of Chemicals (REACH).
•
Regulation (EC) No. 1935/2004 regarding materials and objects intended to come into contact with
food.
•
Regulation (EU) No. 10/2011 on plastic materials and objects intended for the purpose
of coming in contact with food.
•
Regulation (EC) No. 2023/2006 on good manufacturing practice for materials and articles
intended to come into contact with food.
For compliance, the following harmonized standards have been applied:
•
EN 60335-1:2012 + AC:2014 + A11:2014 + A13:2017 + A1:2019 + A2:2019 + A14:2019
•
EN 60335-2-15:2016 + A11:2018 + A1:2021 + A2:2021 + A12:2021
•
EN 55014-1:2017 + A11:2020
•
EN IEC 55014-2:2021
•
EN 62233:2008
•
EN IEC 61000-3-2:2019 + A1:2021
•
EN 61000-3-3:2013 + A1:2019
Note: In the event of any changes made to the devices mentioned above without our express permission,
this declaration of conformity will become invalid.
11

TROUBLESHOOTING

Problem
First use: The machine does not
heat up.
The machine is switched on, but
the machine does not work.
Translation of the original German user manual
Possible Cause
The Fill Mode could not be
carried out or could not be
finished.
Water has been refilled; PID-
display is off
PID-display is turned off: There
is not enough water in the fresh
water tank
The water tank is not fixed
properly.
Troubleshooting
Make sure that there is enough
water in the water tank
Position the brew lever upwards
for at least 30 seconds at a time
(see chapter 5 First Use)
Switch the machine off and on.
Make sure that the floater in the
water tank is in the correct
position. The side of the floater
with the magnet point must face
towards the inside of the
machine. The floater itself must
be inserted with the magnet
point on the upper part of the
floater side.
Refill water.
Fix the water tank properly.
ENGLISH
35