Manual Adjustment Of The Brewing Pressure; Pid-Display Functions; Programming The Temperature Of Both Boilers - Profitec Pro 600 Bedienungsanleitung

As soon as you start a withdrawal while the machine is heating up ('UP' is shown in the
display), the Fast Heat Up is interrupted; in this case, the brewing group needs a little
longer to reach the desired temperature.
If you do not want to use the Fast Heat Up, you can set the function to 'off' under the FH
entry by calling up the menu (hold down both buttons on the display).
9. Now the machine is ready for use again.

6.2 Manual adjustment of the brewing pressure

You can individually adjust and change the brewing pressure by turning the adjusting screw, choosing a
value between approx. 8.5 and 12 bar.
To adjust the brewing pressure, proceed as follows:
10. Remove the drip tray.
11. Place the portafilter with the blind filter (filter without holes) into the brew group.
12. Operate the group lever and read pressure at the pump pressure gauge.
13. Choose the desired brewing pressure by turning the adjusting screw with a coin or a flat screwdriver.
You can reduce the brewing pressure by turning the screw anti-clockwise and increase it by turning
it clockwise.
14. You can read the programmed pump pressure on the pump pressure gauge.
15. Replace the Drip tray. Now place the group lever back into the lower position to stop brewing.
Unclamp the portafilter and replace the blind filter with a coffee filter.
16. Now the machine is ready for use again.

6.3 PID-display functions

The following explains the different programming options of PID control.
6.3.1

Programming the temperature of both boilers

During normal operations, the temperatures of the coffee boiler (t1, period in the 1st position) and the
steam boiler (t2, period in the 2nd position) are indicated alternately.
The controls are factory pre-set so that both boilers are heated consecutively, whereby the coffee boiler
(t1) has priority. This means that the steam boiler (t2) is activated only after the programmed temperature
of the coffee boiler has been reached.
Please take the following steps to program the temperature of both boilers:
1. Switch the machine on in order to activate both boilers (switch in
position "2"). The temperature of either boiler is of no importance in
programming. Both heaters are inactive during programming.
+ –
2. Press and at the same time until 't1' (coffee boiler) appears on the
display,
+
3. Press in order to progress to the submenu of 't1' and to change the
temperature value. The nominal temperature value is displayed.
4. Quickly press
Translation of the original German user manual
–
to decrease
+
to increase
ENGLISH
27