Parkside Performance PHDP 180 B2 Originalbetriebsanleitung Seite 32

GB IE
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not work
Device does not convey water
No pressure in device
Water system leaky
Strong pressure fluctuations
Disposal/
environmental
protection
The device, accessories and packaging should
be properly recycled. If you have any ques-
tions regarding disposal, contact your local
32
Possible cause
On/Off switch (32) turned off
No mains power supply
Incorrect voltage supply
Air locks in the pressure washer
Air locks in the pressure washer Bleeding, p. 30
Pressure loss in line
Connections not correctly in-
stalled
Water connection (28) leaky
3-in-1 nozzle (23) is dirty
3-in-1 nozzle (23) clogged
waste management provider or the service
centre.
Error correction
Check the position of the On/
Off switch
Check the socket, mains connec-
tion cable, plug and fuse and
have them repaired by a quali-
fied electrician if necessary.
Check whether the electrical sys-
tem matches the information on
the type plate
Turn the device on and press the
switch lever (17).
Bleeding, p. 30
Check the water supply
Turn off the device and discon-
nect it from the mains. Reconnect
the device to the water supply
(see Establishing a water supply,
p. 27)
Turn off the device and discon-
nect it from the mains. Change
the quick connector for the
garden hose (29) including seal-
ing ring (see Spare parts and
accessories, p. 35)
Rinse the 3-in-1 nozzle (23)
with water. If required, clean the
nozzle bore hole with a needle
(see Cleaning, p. 30).
Remove the 3-in-1 nozzle (23)
and ensure that the water can
discharge from the trigger gun
(1) unimpeded.
Electrical devices must not be disposed
of with domestic waste.