Parkside Performance PHDP 180 B2 Originalbetriebsanleitung Seite 31

2. Remove the filter insert (30) from the water
connection.
3. Clean the filter insert under running water.
4. Fit the filter insert and quick connector in the
opposite order.
Replacing the batteries
Replace the batteries if the LC display (15) is
not displaying anything.
Power tools required
• Cruciform screwdriver (not included)
Replacing the batteries
1. Remove the screw from the battery compart-
ment cover (16).
2. Remove the cover of the battery compart-
ment.
3. Replace the batteries (35) in the battery
compartment with new batteries. Pay atten-
tion to the correct polarity when inserting
the batteries in the battery compartment.
4. Press the switch lever (17) on the trigger
gun (1).
✔ The LC display shows the selected pres-
sure. If the LC display is not displaying any-
thing, check whether the batteries are inser-
ted correctly.
5. Insert the cover of the battery compartment.
6. Fasten the cover of the battery compart-
ment using the screw.
Maintenance
The device is maintenance free.
Storage
Information on storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• out of the reach of children
Preparing the device for storage
NOTICE! The pressure washer and accessories
will be destroyed by frost if they are not com-
pletely emptied of water.
1. Completely empty the water from the
device.
• Disconnect the device from the water
supply.
• Turn on the pressure washer with the
On/Off switch (32) for a maximum of 1
minute.
• Press the switch lever (17) on the trigger
gun (1) until there is no more water com-
ing out of the trigger gun (1) or the at-
tachments.
• Turn off the device.
2. Completely empty the water from the ac-
cessories.
3. Store all attachments upright in the holders
with the connection facing downwards.
4. Roll the high-pressure hose around the hose
reel (5).
5. Store the mains connection cable in the
holder (11) provided.
GB IE
31