Torques - ROSE Blend Bedienungsanleitung

8.4 Torques

All nuts and bolts must be tightened with an appropriate torque wrench. Proper use prevents overtightening and breaking
of the bolts.
Components
Saddle clamp
Seat post clamp
Stem
Brake calliper bolts front and rear wheel
Front axle
Rear axle
Cassette lockring
Rear derailleur bolt
Centre lock brake disc lockring
Crank bolt
Bottom bracket
Pedals
Operating elements at the handlebar
Threaded eyelets on the frame
*The torque value must not be exceeded. As a rule, a lower torque is sufficient for a secure hold. Especially when using
assembly paste, the necessary torque is often much lower, because the solid particles in the lubricant significantly
increase the friction.
Tip: The lower the torque value of the bolt, the less stress it puts on the component – this is especially important with
carbon components.
Manufacturer, Torque
Model
all See torque value indicated*
ROSE 4 Nm
Handlebar clamp: 6 Nm
ROSE ALR
Steerer clamp: 6 Nm
all 6 Nm
all 15 Nm
all 15 Nm
all 40 Nm
all 10 Nm
all 40 Nm
all See torque value indicated
BSA
40 Nm
35 Nm
all
See torque value indicated*
all Pay attention to additional instructions from the
handlebar manufacturer!
- 2 Nm
55