Further Information; Torques - ROSE THE BRUCE Bedienungsanleitung

6.3

Further information

Want to adjust, replace or service components yourself and according to your own requirements? If you are certain
that you have sufficient knowledge and skills for it, you will find all necessary information about these tasks on the
respective manufacturer's website. Please bear in mind that you take responsibility for all work that you carry out by
yourself.
6.4

Torques

All nuts and bolts must be tightened with an appropriate torque wrench. Proper use prevents overtightening and
breaking of the bolts.
Components
Reverse
Saddle clamp
Brake calliper bolts front and rear wheel
Front axle
Rear axle
Cassette lockring
Mounting bolt rear derailleur
Mounting bolts brake discs
Centre lock brake disc lockring
Mounting bolt of crank
Bottom bracket
Pedals
Operating elements at the handlebar
Rear dropout bearing points
*The torque value must not be exceeded. As a rule, a lower torque is sufficient for a secure hold. Especially when
using assembly lubricant, the necessary torque is often much lower, because the solid particles in the assembly
lubricant significantly increase the friction.
Tip: The lower the torque value of the bolt, the less stress it puts on the component – this is especially important
with carbon components.
38
Manufacturer, Torque
Model
Steerer clamp: 5 - 6 Nm
Handlebar clamp:
Black One
• upper clamp bolts 6 Nm
• lower clamp bolts 1 Nm
ROSE 6 Nm
all 6 Nm
all See manufacturer's instructions
all See manufacturer's instructions
all 40 Nm
all 10 Nm
all 6.2 Nm
all 40 Nm
all See torque value lasered on
BSA
40 Nm
35 Nm
all
See torque value lasered on*
all Pay attention to additional instructions from the
handlebar manufacturer!
ROSE See "Frame details" for the respective frame on
rosebikes.com