Installing The Pedals - ROSE Blend Bedienungsanleitung

3.6 Installing the pedals

One of the pedals has a right- and the other a left-hand thread.
Most pedals have the letter "L" and "R" stamped on for the mounting side. Some pedals come with a groove in
the of the left pedal axle.
For more details see the manufacturer's manual.
1. Check if your bike was supplied with washers and slide both
washers onto the pedal axles – if present.
2. Turn the left pedal anti-clockwise to screw it into the thread of
the left crank arm and tighten the pedal to a torque of 35 Nm.
3. Turn the right pedal clockwise to screw it into the thread of the
right crank arm and tighten the pedal to a torque of 35 Nm.
Your bike is now completely assembled. Before riding off, you should follow the steps described in the chapters "Getting
started for your first ride and getting used to your new bike" and "Before your ride".
44
35 Nm
35 Nm