Certificates And Approvals - Endress+Hauser iTEMP TMT85 Bedienungsanleitung

TMT85 Identification
2.3

Certificates and approvals

On leaving the factory, the device was in perfect condition from the point of view of safety. The
device complies with the standards EN 61 010-1 "Protection Measures for Electrical Equipment
for Measurement, Control, Regulation and Laboratory Procedures" and with the EMC
requirements of IEC/EN 61326.
2.3.1 CE mark, declaration of conformity
The device meets the legal requirements of the EU Directives. The manufacturer confirms a
positive completion of all tests by fitting the unit with a CE mark.
2.3.2 Certification Foundation Fieldbus™
The device meets all the requirements of the following specifications:
• Certified in accordance with FOUNDATION Fieldbus™ specification
• FOUNDATION Fieldbus™ H1
• Interoperability Test Kit (ITK), revision status 5.0.1
• Physical Layer Conformance Test of the Fieldbus FOUNDATION™ (FF-830 FS 1.0)
An overview of other approvals and certificates can be found in the Operating Instructions on
CD-ROM.
Endress+Hauser 25