Kärcher MIC 26C Bedienungsanleitung Seite 56

8.6.2 Operations
 Operation of the attachment unit is done with the joy-
stick; for more about this, see the "Joystick function"
chapter.
8.6.3 Connect the marker lamps (option)
 Route the cables as shown above.
 Connect the plug on the rear of the sweeper.
8.6.4 Prerequisites for operation
– If no caster is attached, the balance weight (option)
must be attached to the rear of the machine for driving
on public roads, when the waste container/water tank is
removed.
Note:
Removing the waste container/fresh water tank will in-
crease the driving stability and the driver's view.
8.7 Caster
8.7.1 Mount the attachment block
 Shut the motor off, remove ignition key.
1
1 Safety pin
2 Attachment block
 Unlock the safety bolt by turning it and pull it out.
 Slide the attachment block into the two square pipes on
the rear of the machine.
 Slide in the safety bolt and lock it by turning it.
56
1
2
19
-
EN
 Insert the spray guard to protect the radiator from
sprayed materials.
8.7.2 Fasten the roller caster
1 Holding pin
2 Safety pin
3 Folding plug
 Pick the roller caster up and hook the holding pins into
the guide slots at the bottom of the mounting block.
Use the guide slots located closer to the vehicle.
 Align the roller caster and fasten using the safety bolt.
 Secure the safety block against sliding out with the fold-
ing plug.
2
3
1