Kärcher MIC 26C Bedienungsanleitung Seite 40

3.1.2 Ingredients (REACH)
The latest information on ingredients can be found under:
www.kaercher.de/REACH
3.1.3 Disposal of the worn out vehicle
Worn out vehicles contain valuable recyclable materials
that should be recycled properly. We recommend to coop-
erate with a waste management company for the disposal
of your vehicle.
3.2 Warranty
The warranty terms published by our competent sales
company are applicable in each country. We will repair po-
tential failures of your accessory within the warranty period
free of charge, provided that such failure is caused by
faulty material or defects in fabrication. In the event of a
warranty claim please contact your dealer or the nearest
authorized Customer Service center. Please submit the
proof of purchase.
3.3 Accessories, spare parts, upgrade kits
Only accessories, spare parts and upgrade kits that are
approved by the manufacturer may be used.
To avoid risks, all repairs and replacement of spare parts
may only be carried out by the authorised customer ser-
vice personnel.
For additional information about spare parts, please go to
the Service section at www.kaercher.com.
3.4 Symbols in the operating instructions
DANGER
Warns about immediate danger which can lead to severe
injuries or death.
WARNING
Warns about possible danger which could lead to severe
injuries or death.
CAUTION
Points out a possibly dangerous situation which can lead
to light injuries or property damage.
ATTENTION
Pointer to a possibly dangerous situation, which can lead
to property damage.
4 Safety instructions
4.1 General notes on safety
– The machine with working equipment must be checked
to ensure that it is in proper working order and is oper-
ating safely prior to use. Otherwise, the appliance must
not be used.
– If the appliance is used in hazardous areas (e.g. filling
stations) the corresponding safety provisions must be
observed. It is not allowed to use the appliance in haz-
ardous locations.
40
3.5 Symbols on the machine
CAUTION
Risk of burns on account of hot surfaces! Al-
low the exhaust to cool down sufficiently be-
fore starting work on the machine.
CAUTION
Risk of burns on account of hot hydraulic
quick couplers! Wear gloves while separating
the couplings.
DANGER
Danger of crushing. Make sure that no per-
sons are present near the arm hinges.
WARNING
Danger of crushing. Keep hands off the
marked location.
CAUTION
Risk of damage. Do not enter.
DANGER
Danger of tipping. Only drive on terrain with a
max. of 10% incline.
Fill in coolant here.
4.2 Work clothing
– Always use appropriate gloves while working on the de-
vice.
– Ensure that the operator wears tight-fitting clothes.
Wear safety shoes and avoid loose clothing.
– Wear suitable headgear so that braids or long hair can-
not get caught in rotating parts.
– Do not wear jewellery, rings or the like during work.
3
-
EN