Kärcher MIC 26C Bedienungsanleitung Seite 55

8.3.3 Prerequisites for operation
– The balance weight (option) must be attached to the
rear of the machine for driving on public roads.
– Set the motor rpm to high.
Note:
The wear on the ground can be reduced by using the up-
grade kit for grass tyres (2.851-089.0).
Removing the waste container/fresh water tank will in-
crease the driving stability and the driver's view.
8.3.4 After mowing
 Lower the working appliance and the suction opening.
 Clean the top surface of the suction opening with com-
pressed air (for sweepers).
 Clean the cooler.
8.4 Front brush roller
8.4.1 Connecting the hydraulic lines
1 Hydraulic couplings AUX2
Hydraulic couplings, swivel drive
2 Hydraulic couplings main PTO
Hydraulic couplings, brush roller drive
3 Hydraulic hoses, brush roller drive
4 Hydraulic hoses, swivel drive
8.4.2 Operations
 Operation of the attachment unit is done with the joy-
stick; for more about this, see the "Joystick function"
chapter.
8.5 Snow removal shields
8.5.1 Connecting the hydraulic lines
1 Hydraulic couplings AUX2
2 Hydraulic couplings AUX1
8.5.2 Operations
 Operation of the attachment unit is done with the joy-
stick; for more about this, see the "Joystick function"
chapter.
8.5.3 Connect the marker lamps (option)
 Route the cables as shown above.
 Connect the plug on the rear of the sweeper.
8.5.4 Prerequisites for operation
– If no caster is attached, the balance weight (option)
must be attached to the rear of the machine for driving
on public roads, when the waste container/water tank is
removed.
Note:
Removing the waste container/fresh water tank will in-
crease the driving stability and the driver's view.
8.6 Snow blower
8.6.1 Connecting the hydraulic lines
1
1 Hydraulic couplings AUX2
2 Hydraulic couplings AUX1
3 Hydraulic couplings main PTO
18
-
EN
2
3
55