3M PROTECTA Rebel 3100418 Bedienungsanleitung Seite 12

7.3 LABELING: Figure 10 illustrates Rebel SRL labeling. All labels must be present and fully legible.
1 Visually inspect unit. Read instructions.
2 Inspect locking action of SRL. One user maximum.
3 Correct way of connecting SRL to harness.
4 May be connected to an anchorage point above or level with the dorsal D-Ring. 310 lbs (140 kg) maximum.
5 Temperature usage range -40°C + 60°C.
6 Maximum capacity 140 kg.
7 Always allow the lifeline to recoil back into the SRL under control.
8 Do not repair.
9 Store indoors.
10 Do not place the SRL housing on an edge during use.
11 Do not remove label.
Component:
SRL
(Figure 11)
Web Lifeline
(Figure 12)
Load Indicator
(Figure 13)
End Connectors
(Figure 1)
11
D
C
A
E
Table 2 – Inspection Checklist
Inspection:
Inspect for loose fasteners and bent or damaged parts.
Inspect the Housing (A) for distortion, cracks, or other damage.
Inspect the Swivel (B) and Swivel Eye (C) and Carabiner (D) for distortion,
cracks, or other damage. The Swivel should be attached securely to the SRL,
but should pivot freely. The Swivel Eye or Integral Connector should rotate
freely in the Swivel.
The Web Lifeline (E) should pull out and retract fully without hesitation or
creating a slack line condition.
Ensure the SRL locks up when the Lifeline is jerked sharply. Lockup should be
positive with no slipping.
All labels must be present and fully legible (see Figure 10).
Inspect the entire SRL for signs of corrosion.
Inspect the web lifeline for concentrated wear, frayed strands, broken yarn,
burns, cuts, and abrasions. The lifeline must be free of knots throughout its
length. Inspect for excessive soiling, paint build-up, and rust staining. Inspect
for chemical or heat damage indicated by brown, discolored, or brittle areas.
Inspect for ultraviolet damage indicated by discoloration and the presence of
splinters and slivers on the lifeline surface.
Inspect the Load Indicator to determine if it has been activated. There should
be no evidence of elongation and the cover should be secure and free of tears
or other damage.
Figure 1 identifi es the End Connectors that may be included on your Rebel SRL
model. Inspect Snap Hooks, Carabiner, Rebar Hooks, etc. for signs of damage,
corrosion, and proper working condition. Where present: Swivels should rotate
freely, and Carabiner and Hook Gates should open, close, lock, and unlock
properly.
Cut
Frayed
B
Heavily
Soiled
Welding
Burns
12
12
Pass
13
Deployed and
Torn/Frayed
Webbing
Torn or
Broken
Cover
Fail