Stopping The Engine - Rotax Fr 125 Max Betriebsanleitung

Press ON/OFF circuit breaker firmly and release so that only
the black part of the button is visible. Now the ignition circuit is
closed and the battery supplies the ignition system with voltage
(fig. 7).
Press start button (max. 5 sec.) until engine starts running. If
the engine won't start, repeat starting procedure after a few
seconds.
After engine start, take choke back slowly until engine idles
smoothly without choke.
Warning: Always wear protective clothing for kart operation (helmet, overall, gloves, shoes,
neck and rib guards).
Warning: Do not touch the engine, the radiator or the exhaust system during and
immediately after kart operation. Risk of burning.
Warning: During kart operation, beware of body or clothing contact with moving components
of the kart.
Warning: Comply with the safety advice of the kart manufacturer.
Warning: Inspect any part prone to wear (tyres, drive chain, bearings etc.) before each kart
event for good condition, in accordance with the directives of the kart
manufacturer.
Warning: Keep to running-in procedure as directed.
Warning: Operate engine only within the specified limits.
Warning: Never run the fuel tank empty.

7. Stopping the engine

Firmly press and release button of ON/OFF circuit breaker. The black end and the white ring
marking of button are visible, indicating that the ignition circuit is open, and that the engine will
stop.
Note: The ON/OFF circuit breaker serves also as an emergency stop if engine operation
must be interrupted (e.g. carburetor piston stuck in full throttle position).
Note: The circuit for the ignition system should be closed by the ON/OFF circuit breaker
for engine operation only.
Seite/page 73/80
Operating Instructions FR 125 MAX
FR 125 MAX
Fig. 13
Ausgabe/edition 07/99