Connecting The Battery - Rotax Fr 125 Max Betriebsanleitung

Attach the exhaust system via the two rubber mounts on the chassis supports, such that the
sealing of the ball joint between cylinder and exhaust system will not be impaired and the
rubber mounts are without additional unnecessary stress.
Note: Condition of the exhaust system installation must be verified at each change of the
chain length or the chain tension. Adjust as required.
Attention: Bad sealing on ball joint of exhaust systems results in poor engine performance.

19. Connecting the battery

Connect the black cable of the battery harness on minus terminal of battery (see fig. 5).
Connect the red cable of the battery harness on plus terminal of battery (see fig. 5).
Attention: Always connect the minus terminal first and then the plus terminal. Disconnect the
battery in reverse sequence.
Note: In addition, secure both plug connections on the battery with a rubber band so that
the centrifugal forces at cornering will not detach connections.
Seite/page 57/80
Installation Instructions FR 125 MAX
FR 125 MAX Ausgabe/edition 07/99