Sartorius Stedim Biotech Flexsafe 3D Bag For Palletank Benutzerhandbuch Seite 7

Fig. 8: Preparation of the Palletank
®
Fig. 9
Fig. 10
3.2 Flexsafe 3D Bag Installation, 100L, 200L, 500L
®
1. Obtain a packaged Flexsafe
smooth table with no sharp angular corners.
– If you are using a Palletank
for all bags including the 100L.
– For all other Palletank types a 100L Flexsafe
®
200L Palletank as they share the same footprint.
®
2. Check that the irradiation indicator on the label is red to indicate irradiated
product. Record the batch number of the bag (as seen on the product label)
(see Fig. 8).
3. On a table, position the bag so that both the bottom port and the 4-port system
are facing you with the bottom port underneath. This correct positioning will
ensure a proper insertion of the Flexsafe
4. To open and remove the secondary (external) packaging (see Fig. 9):
− Tear open one of the corners and open completely by tearing along the weld.
− Remove the secondary packaging by sliding it away from the Flexsafe
5. Check that the Flexsafe
®
that could compromise the sterility.
6. Repeat the 4. and 5. steps for the primary (internal) packaging.
7. Unfold the bag and remove any adhesive tape or protective foam from the
Flexsafe 3D Bag (see Fig. 10).
®
Flexsafe
3D Bag of the appropriate size and position it on a
®
for Shipping, the bag size matches Palletank
®
3D Bag should be used with a
®
3D Bag in the Palletank
®
3D Bag secondary packaging is free from any damage
® 3D System 100L, 200L, 500L Instructions for Use
size
®
.
®
3D Bag.
®
7