Sartorius Stedim Biotech Flexsafe 3D Bag For Palletank Benutzerhandbuch Seite 11

Fig. 21
Fig. 22
Fig. 23
5. After 10% of the bag's nominal capacity for 200L and 500L or 20% of the bag
capacity for the 100L, stop the filling and perform the following steps
(see Fig. 21):
− Remove the top port of the bag from the front side of the Palletank
it to sit freely within the Palletank
− Manually adjust each bag corner to its appropriate position
− If you use the Palletank
doors and secure the four locking systems.
Sartorius Stedim Biotech recommends the use of the Self Deploying accessory which
eases the installation and the filling of the Flexsafe
eliminates risky bag manipulations post installation. As the bag fills, the Deploying
Accessory removes all tension from the top of the bag by allowing the top tubing to
gradually slide along the Accessory allowing for a reproducible and effortless bag
deployment to its appropriate position within the Palletank
Process Fluid Handling. Please contact your sales representative for further details.
6. Fill the bag to its nominal capacity (see Fig. 22) and stop the filling.
7. If you have chosen to fill through the top, empty the liquid contained in the
filling line into the bag by raising the tube vertically over the bag (see Fig. 23).
8. Close the clamps (see Fig. 17) and disconnect the filling line.
Flexsafe
®
for In-Process Fluid Handling, close the hinged front
®
bag, saves operator time and
®
® 3D System 100L, 200L, 500L Instructions for Use
and allow
®
for Storage and In-
®
11