Werbung
Verfügbare Sprachen
Verfügbare Sprachen
9. Specifications
Model
Current consumption
Supply voltage UB
Load
Settling time
Ingress Protection
(per EN/IEC 60529)
Electrical protection
Vibration resistance
Shock emission
Immunity
1) The load pins with ignition protection type "ib" must only be supplied using galvanically-isolated power supplies.
Suitable supply isolators are also optionally available, e.g. order number: 14255084.
2) Relative linearity error is specified in accordance with guideline VDI/VDE/DKD 2638 chapter 3.2.6.
3) This value can result if 100 % F
4) Other signal jumps are realisable on request.
5) Other settling times possible on request.
Attention: For ATEX equipment, observe the additional operating instruction: 14537280 for Ex
equipment. ATEX equipment is labeled and certified under the brand tecsis.
Mounting situation of the load pin
Pin retainer (in accordance with DIN 15058)
Dimensioning: The customer-specific load pin drawing of the respective order number has priority.
For further specifications, see WIKA data sheet FO51.43 and the order documentation.
Operating instructions, models F5301, F53C1, F5308, F53C8, F53S8
F53C8
ATEX/IECEx EX ib
Current output
■
4 ... 20 mA,
2-wire: signal current
DC 10 ... 30 V for current output
< (UB – 10 V) / 0,024 A for current output
■
> 10 kΩ for voltage output
■
≤ 2 ms (within 10 ... 90 % F
IP67
Reverse polarity protection, overvoltage and short-circuit resistance
20 g, 100 h, 50...150 Hz (according to DIN EN 60068-2-6)
In accordance with DIN EN 60068-2-27
In accordance with DIN EN 61326-1/DIN EN 61326-2-3
■
EMC-strengthened versions
■
acts at 90° to the axis.
nom
F
F / 2
F / 2
F53C8
1)
ATEX/IECEx Ex d
Current output
■
4 ... 20 mA,
3-wire: < 8 mA
5)
)
nom
Ground
connection
M6-12/8 deep
F5308
signal jump
Current output
■
4 ... 20 mA,
EN
3-wire: < 8 mA,
Voltage output:
■
< 8 mA
"Force direction"
symbol applied
35
Werbung
