Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4. Transport, packaging and storage
4. Transport, packaging and storage
4.1 Transport
Check the load pin for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
CAUTION!
Damage through improper transport
With improper transport, a high level of damage to property can occur.
▶
When unloading packed goods upon delivery as well as during
internal transport, proceed carefully and observe the symbols on the
packaging.
▶
With internal transport, observe the instructions in chapter 4.2
"Packaging and storage".
As precision measuring instruments, transducers require careful handling during
transport and mounting. Load impacts during transport (e.g. hitting a hard surface) can
lead to permanent damage, resulting in measured errors in the subsequent measuring
operation.
4.2 Packaging and storage
Do not remove packaging until just before mounting.
Keep the packaging as it will provide optimum protection during transport (e.g. change
in installation site, sending for repair).
The material of the measuring spring and the ingress protection class can be found in
data sheets FO51.18 for the models F5301, F53C and FO51.43 for the models F5308,
F53C8, F53S8.
Permissible conditions at the place of storage:
Storage temperature: -40 ... +85 °C [-40 ... 185 °F]
■
Humidity: 35 ... 85 % relative humidity (non-condensing)
■
Avoid exposure to the following factors:
Mechanical vibration, mechanical shock (putting it down hard)
■
Dust, dirt, and other objects may not be deposited in such a way that they form a
■
force shunt with the measuring spring, since this will falsify the measuring signal.
Operating instructions, models F5301, F53C1, F5308, F53C8, F53S8
EN
13
Werbung
