Parkside PSBS 240 C2 Originalbetriebsanleitung Seite 34

GB MT
Trouble Shooting
Always disconnect the plug from the mains socket before working.
Danger of electric shock.
Problem
Device doesn't start
Grinding tools do
not move although
the engine is
running
Drive is blocked
Engine is slower
and stops
Grinding disc does
not rotate smoothly,
abnormal noises
can be heard
Bad grinding
output
34
Possible Cause
Mains voltage missing
Main circuit breaker is tripped
On/off switch (14) may be
defective
Engine faulty
Grinding disc nut (
loose
Grinding belt (10) loose
Grinding belt (10) blocking
drive
Workpiece, remaining work-
pieces or remaining grinding
tools block drive
Device is overloaded through
workpiece
Grinding disc nut (
loose
Grinding disc (19) faulty
Spark protection (1) or work-
piece support (6/18) set incor-
rectly
Grinding belt (10) worn
Error correction
Check the socket, mains cable,
line, mains plug, repairs to be
carried out by qualified electri-
cian if necessary, check main
circuit breaker.
Repair by Customer Care
Tighten grinding disc nut (see
19a)
„Changing the grinding disc")
Increase grinding belt tension
(see „Changing the grinding
belt")
Re-mount grinding belt (see
„Changing the grinding belt")
Remove blockages
Reduce pressure on grinding tool
Workpiece unsuitable
19a) Tighten grinding disc nut (see
„Changing the grinding disc")
Change grinding disc
Set spark protection or work-
piece support (see „Assembly")
Change grinding belt