Parkside PSBS 240 C2 Originalbetriebsanleitung Seite 31

• Ensure that the rotation speed stated
on the grinding disc (19) is the same or
higher than the nominal rotation speed
of the device.
• Ensure that the grinding disc dimensions
match those of the device.
• Only use flawless grinding discs. Per-
form a ringing test. When striking
the grinding disk with a plastic ham-
mer, this should result in a clear sound.
• Never re-drill a locating hole which is
too small to make it larger.
• Never use separate bushings or ad-
apters in order to make grinding discs
whose hole is too large fit the device.
• Do not use any saw blades.
• To clamp the grinding tools only use the
clamping flange provided. The pads
between the clamping flange and the
grinding tools must be made of elastic
materials e.g., rubber, soft cardboard etc.
• Always reassemble the device comple-
tely after replacing the grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.
1. Remove the spark protection (
(see „Assemble/set spark protection).
2. Loosen the 3 fixing screws (15) and
remove the grinding disc cover (16).
3. Loosen the fixing screws (
remove the grinding belt cover (
(see „Changing the grinding belt").
4. Unscrew the grinding disc nut (19a) in the
clockwise direction, by holding the nut of
the opposite roller of the grinding belt in
place (see small image). Hold it tight with
a 19 mm socket wrench or pliers.
5. Remove the clamping flange (19b) and
the grinding disc (19).
6. Set up the new grinding disc (19) and
the clamping flange and manually screw
the grinding disc nut (19a) in the anti-
clockwise direction.
7. Screw the grinding disc cover (16).
8. Re-fasten the sanding belt cover (
using the mounting screws (
9. Set the spark protection (
workpiece support (
distance between the grinding disc (19)
is max. 2 mm (see „Assembly").
10. Test run: Before starting work and
after each change of grinding disk,
carry out a test run of at least 60
seconds with no load. Switch off the
equipment immediately if the disk runs
lumpy, substantial vibrations occur, or
abnormal noises are generated.
Transport
1)
11) and • Carry the device with two hands. Grip it
12) at the device base and motor housing.
The grinding disc nut must not be
screwed too tightly in order to avoid a
breaking of the grinding disc and nut.
Disconnect the plug before adjust-
ment, maintenance or repair.
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
GB MT
12)
11).
1) and the
18) so that the
31