Parkside PSBS 240 C2 Originalbetriebsanleitung Seite 29

Workpiece supports
assemble/set
1. Screw the workpiece supports (6/18)
on to the device.
2 positions (see
for the tape loop.
2. To do so, use the screws (5a/17a),
washers (5b/17b), toothed lock washer
(5c/17c) and star grip nuts (5/17) pro-
vided.
3. Set the workpiece support of the grin-
ding belt (19) with the star grip nut (17)
so that the distance between the grin-
ding disc (19) and the workpiece sup-
port is max. 2 mm (see small image).
Periodically readjust the workpiece
support in order to offset the wear
and tear of the grinding disc
(distance max. 2 mm).
Screw device on to
workbench
Screw the device onto the workbench with
4 screws and nuts.
Insert the screws through the 4 bore holes
(13) on the base of the device.
The screws and nuts required for
assembly are not part of the scope
of delivery.
Operation
Caution!
Risk of injury!
- Always disconnect the plug from the
mains socket before working.
- Use only grinding disks and accessories
recommended by the manufacturer. The
use of other insertion tools and other
accessories may cause risk of injury.
A + B) are possible
- Only use grinding tools which bear in-
formation about the manufacturer, type
of binding, dimension and permitted
number of revolutions.
- Only use grinding discs where the prin-
ted rotational speed is at least as high
as what has been specified on the name
plate of the device.
- Do not use broken, cracked or otherwise
damaged grinding disks.
Change any damaged or heavily worn
grinding discs.
- Only use the device when both grinding
belt and the grinding disc are assembled.
- Never operate the device without the
visual protection disk.
- Always use protective goggles even if
you are protected against sparks.
- Always inspect the grinding disc before
starting the device:
Check the distance between the spark
protection and grinding disc as well as
workpiece support and grinding disc
(distance maximum 2 mm).
- The grinding disc must be replaced once
the spark protection and workpiece sup-
port on the grinding disc do not have
distance of max. 2 mm.
- Switch on the equipment only when it is
safely installed on the work surface.
Keep your hands away from
the grinding disc and grind-
ing belt when the device is in
operation. Injury hazard!
Switching on and off
Ensure that the mains voltage match-
es the specifications on the rating
plate.
Connect the equipment to the mains.
GB MT
29