Parkside PSBS 240 C2 Originalbetriebsanleitung Seite 28

GB MT
hands to come into contact with the
grinding belt or grinding disc.
• The workpiece gets hot during grinding.
Do not touch the machined area, allow
it to cool down. There is a risk of burn-
ing. Do not use coolants or the like.
• If you are tired or have consumed al-
cohol or tablets, do not work with the
device. Always have a break on time.
• Switch the device off and remove the
mains plug
- to loosen a blocked insertion tool,
- if the connection line is damaged or
entangled,
- in case of unusual sounds.
• Only operate the device in an upright,
standing position and ensure you have
secure footing.
Residual risks
Even if properly operating and handling
this electric tool, some residual risks will
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Lung damage, if suitable respiratory
protection is not worn.
b) Hearing damage, if suitable ear pro-
tection is not worn.
c) Damages to health due to
- touching the area of the grinding tool
which was not covered;
- the ejection of pieces from workpiece
or damaged grinding discs.
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
28
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the risk
of serious or lethal injuries, we rec-
ommend that persons with medical
implants consult their doctor and the
manufacturer of their medical im-
plant before operating the machine.
Assembly
Caution!
Risk of injury!
- Ensure that you have sufficient space
in which to work, and that you do not
endanger other people.
- Always fasten the device on to the work
surface with screws featuring the suf-
ficient length and thickness in order to
maintain control of the device.
- All covers and protective devices must
be assembled properly before commis-
sioning.
- Disconnect the mains plug before chan-
ging the setting on the device.
Spark protection
assemble/set
1. Screw the spark protection (1) using the
adjusting screw (2) and the nut (2a) on
to the protective hood (3).
To do so, you will need a screwdriver
and a ring spanner
(AF 8 mm), used to hold it in place.
2. Set the spark protection (1) with
the adjusting screw (2) so that the
distance between the grinding
disc (19) and the spark protection
is max. 2 mm (see small image).
Periodically readjust the spark pro-
tection in order to offset the wear
and tear of the grinding disc
(distance max. 2 mm).