Parkside PSBS 240 C2 Originalbetriebsanleitung Seite 24

GB MT
Do not dispose of electrical
equipment in household waste.
Dimensions grinding disk
Dimensions grinding belt
Symbols in the manual:
Warning symbols with in-
formation on damage and
injury prevention.
Instruction symbols with information
on preventing damage.
Connect the device to the power
supply.
Switch off the device and unplug
the mains plug.
Help symbols with information on
improving tool handling.
General Safety Instructions
for Power Tools
WARNING! Read all safety
notices, instructions, illustra-
tions and technical data that
have been provided with this
power tool. Failure to comply with
these and the following instructions
may result in electric shock, fire
and/or serious injuries.
Save all safety instructions and
guidelines for the future.
The term "power tool" used in the safety inst-
ructions refers to mains-operated power tools
(with a mains cable) and to battery-operated
power tools (without a mains cable).
24
1) Occupational Safety
a) Keep your work area tidy and
well lit. Working in areas that are
untidy or without lighting can result in
accidents.
b) Do not work with the power
tool in a potentially explosive
atmosphere where flammable
liquids, gases or dust are pre-
sent. Power tools generate sparks
that can ignite dust or vapours.
c) Keep children and other per-
sons away from the area while
the power tool is in use. Distrac-
tions can cause you to lose control of
the power tool .
2) Electrical safety
a) The plug of the power tool must
fit into the socket. The plug must
not be modified in any way. Do
not use adapter plugs with po-
wer tools that have a protective
earth. Unmodified plugs and matching
sockets reduce the risk of electric shock.
b) Avoid body contact with earthed
surfaces such as pipes, radia-
tors, cookers and refrigerators.
There is an increased risk of electric
shock if your body is earthed.
c) Do not expose the power tool
to rain or wet conditions. The
penetration of water into a power tool
increases the risk of electric shock.
d) Never use the power cable to
carry or hang the power tool or
to pull the plug out of the socket.
Keep the power cable away
from heat, oil, sharp edges and
moving parts. Damaged or untidy
power cables increase the risk of elec-
tric shock.