Parkside PSBS 240 C2 Originalbetriebsanleitung Seite 30

GB MT
1. To switch on, press the "I" On switch
and the device starts up (see 14a).
2. To switch off, press the "0" off switch
and the device switches off (see 14b).
After switching on the device, wait until the
device has reached its max. speed. Only
then must you start with the grinding.
The disk will continue to
run after the equipment is
switched off. There is a risk
of injury.
Test run:
Before starting work and after each
change of grinding disk, carry out a test
run of at least 60 seconds with no load.
Switch off the equipment immediately if the
disk runs lumpy, substantial vibrations oc-
cur, or abnormal noises are generated.
Grinding with the
grinding disc
Fold down the spark pro-
tector (1) when grinding in
order to avoid injury from
sparks.
The arrow on the protective hood
(3) shows the direction of rotation
of the grinding disc.
• Place the workpiece on the workpiece
support (18) and slowly bring it to its
desired angle on the grinding disc (19).
• Move the workpiece slightly from side
to side in order to achieve an optimal
grinding result. This way, the grinding
disc is worn uniformly. Occasionally,
allow the workpiece to cool down.
30
Tape loops
The arrow on the protective hood
(9) shows the direction of rotation
of the grinding belt.
• Firmly hold the workpiece, do not ex-
ert any strong force.
• Move the workpiece slightly from side
to side in order to avoid a one-sided
wear of the grinding belt.
• Always grind the pieces of wood in
the direction of the wood grain in or-
der to avoid chipping.
Change grinding belt
1. Loosen the 2 fixing screws (11) and
hang out the grinding belt cover (12).
2. Press the clamping lever (7) downwards
and detract the grinding belt (10).
3. Place the new grinding belt (10) in the
centre on the upper (20a) and lower
(20b) rollers.
4. Push the clamping lever grinding belt (7)
and mount the grinding belt cover (12).
Set the tape run:
5. The tape run accuracy is set by turning
the adjusting screw for belt run (8).
6. Check the tape run by manually turn-
ing the grinding belt.
7. Re-fasten the sanding belt cover (12)
using the mounting screws (11).
When assembling the grinding belt,
pay attention to the direction of travel.
Change grinding disc
Information
on replacement:
• Never operate the device without pro-
tective equipment.