Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Warning! This power tool generates an electromagnet-
ic field during operation. This field can impair active or
passive medical implants under certain circumstances.
In order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool.
ATTENTION: Use only E10 unleaded petrol as fuel.
m Use of petrol
m Danger to life! Petrol is toxic and highly flam-
mable.
• Only store petrol in containers (canisters) designed
and tested for this purpose. The tank caps must al-
ways be properly screwed on and tightened. Defec-
tive caps must be replaced for safety reasons.
• Keep petrol away from sparks, open flames, per-
manent flames, heat sources and other sources of
ignition. Do not smoke!
• Refuel outdoors only and do not smoke while refu-
elling.
• Before refuelling, switch off the combustion engine
and let it cool down.
• Petrol must be filled before starting the combustion
engine. While the combustion engine runs or if the
machine is hot, the fuel cap must not be opened and
petrol must not be filled.
• Open the fuel cap carefully and slowly. Wait for the
pressure to equalise and only then remove the fuel
filler cap completely.
• Use a suitable funnel or filler pipe for refuelling so
that no fuel can spill onto the combustion engine and
housing or lawn.
• Do not overfill the fuel tank!
• To leave room for the fuel to expand, never fill the
fuel tank beyond the lower edge of the filling nozzle.
Observe additional information in the combustion
engine user manual.
• If petrol has overflowed, do not start the combustion
engine until the petrol-contaminated area has been
cleaned. Avoid starting the engine until the fuel va-
pours have evaporated (wipe dry).
• Always wipe up spilled fuel immediately.
• If petrol has got on clothing, it must be changed.
• The tank cover must be properly screwed on and
tightened after each refuelling operation. The device
must not be put into operation without the original
tank cover screwed on.
• For safety reasons, check fuel line, fuel tank, fuel
cap and connections regularly for damage, ageing
(brittleness), tight fit and leaks and replace if nec-
essary.
• Only empty the tank outdoors.
• Never use beverage bottles or similar to dispose of
or store operating materials, such as fuel. People,
especially children, could be tempted to drink from it.
• Never store the device with petrol in the tank inside
a building. Any fuel vapours produced can come into
contact with naked flames or sparks and ignite.
• Do not place the device and fuel tank near heaters,
radiant heaters, welding machines or other sources
of heat.
Risk of explosion!
If a defect is detected on the tank, the tank cover or
on fuel-carrying parts (fuel lines) during operation, the
combustion engine must be switched off immediately.
Then consult a specialist dealer.
Residual risks
The device is state-of-the-art and has been built in ac-
cordance with the recognised technical safety rules.
However, individual residual risks can arise during op-
eration.
• Health hazard due to electrical power, with the use
of improper electrical connection cables.
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the "Safety In-
structions" and the "Intended Use" together with the
operating manual as a whole are observed.
• Avoid accidental start-ups of the power generator.
• Use the device in the way that is recommended in
this operating manual. This is how to ensure that
your power generator provides optimum perfor-
mance.
6. Technical data
Power generator
Protection category
Continuous output power P
(COP) (230 V) (S1)
Max. power P
(S2 5 min)
www.scheppach.com
n
(230 V)
max
Digital inverter
IP23M
1.0 kW
1.1 kW
GB | 29
Werbung
