Keeping Liquids And Soups Warm - Silvercrest SEAD 1800 B1 Bedienungsanleitung

RP89015 Einkochautomat LB4 Seite 8 Dienstag, 12. März 2013 4:19 16
2. Cut up fruit and vegetables to the
required size.
3. Fill the preserving jars with food.
Note: Make sure that you layer the
food properly in the jar. That will look
better and make best use of the space
inside.
4. If wished, add sugar or seasonings /
spices.
5. Fill the jars up with water up until just
below the rim.
6. Seal the jars.
Note: Make absolutely sure that they
are properly sealed.
7. Place the rack 12 in the container 3.
8. Place the jars you have prepared in the
container 3.
Note: The jars can be arranged in the
container 3 in two layers.
9. Add water to the container 3 so that the
jars on top are standing about 3/4 in
water.
10.Place the lid 1 on the container 3.
11. Set the temperature and operating time
(see "6.1 Adjusting settings, switching
on and off" on
"8. Operating times and temperatures"
on page 12).
12. Start the preserving process by pressing
the start/stop button
"6.1 Adjusting settings, switching on
and off" on page 6).
13.As soon as the operating time selected
ends, place a heat-resistant vessel under
the tap 5.
14.Press the lever 4 to let the water out of
the container 3.
15.Allow the jars to cool down before
taking them out of the container 3 .
8
Note: Preserving jars that are still warm
are sensitive to draughts. Where
possible, you should therefore leave
them in the container 3 until they have
cooled right down. Should you need the
appliance beforehand, you can take the
warm jars out, place them on a towel
and cover them up with another towel
until they have cooled right down.
16.Label the jars with the contents and the
date you preserved them.
17. Store your preserves in a dry, dark, cool
place, and they will then keep for up to
a year.

6.3 Keeping liquids and soups warm

This appliance is also ideal for keeping
mulled wine, cocoa, soups and hot pots
warm.
Warning! Make sure there is never too
much liquid in the appliance. The level of
liquid must always be below "MAX". If there
is too much liquid, the appliance might
overflow.
1. Add the liquid to the container 3.
2. Place the lid 1 on the container 3.
page 6 and 3. Turn
temperature 6 to the temperature you
require.
– The temperature is increased in
6 (see
increments of 1 °C;
– A signal sounds every 5 °C;
– The temperature selected is shown on
the
selection 10.
4. Do not select the time but press the
rotary "TIMER" knob 7.
– The display will show a horizontal "8".
5. Press the start/stop button 6.
– The appliance will begin to heat up;
the rotary knob for
display for temperature
the