Description of the Appliance
In the event of missing accessories or any
transport damage, please contact your
dealer.
1 Tank adapter/connecting adapter
2 Connection hose filter/tank
3 Tank (exchanger)
4 Tie down strap
5 Transport rails
6 Frame, navigable
7 Dirt separator with dirt trap
8 Dial gauge
9 Filter
10 Key for pre-filter
Preparation
Transporting the device
Caution
Risk of injury! When moving the plant, en-
sure that the personal strength is not ex-
ceeded.
When transporting the appliance in a
vehicle, transport it upright or lying on
the transport rails and secure it appro-
priately.
6
Unloading
Danger
Risk of injury, risk of damage!
Observe the weight of the appliance when
you load it!
Transport weight
(WS 50) 35 kg
(WS 100) 40 kg
Unloading the plant:
Pull the plant out of the vehicle holding
the axle of the wheels and place it on
the ground via the sill. Use the handle to
completely raise it.
Loading the plant:
Load in reverse order.
Drive the machine
Hold the plant on the handle, tilt it back-
wards and push or pull. After moving,
place the plant securely on an even sur-
face.
2
-
EN
Operation
Daily checks prior to operation
Check plant for leaks.
–
Check battery status (battery status in-
–
dicator in the display dial gauge), re-
place if necessary. Battery type
CR2032.
Check tie down strap, replace as nec-
–
essary.
Check the soiling of the candle, replace
–
as necessary (order no. 6.761-361.0).
Connecting the appliance
Danger
Risk of tipping! Route the connection hoses
in a way that the plant cannot tip over due
to pulling on the hoses.
Tripping hazard! Route the hoses in a way
that they do not cause injuries (e.g. by trip-
ping).
Caution
During use the plant must be set up at a
frost-free location. The necessary connec-
tions to the water supply and the soft water
consumer must be considered.
When connecting the unit, the relevant ap-
plicable standards and the regulations of
the providers must be observed.
1 Outlet soft water
2 Inlet raw water
3 Tank (exchanger)
4 Drain/bleed valve
Connect raw water inlet (town water).
Connect consumer to the soft water
connection outlet.
Producing soft water
Open the water supply and have the
tank (exchanger) filled.
Bleed the system, in order to do so,
open the bleed valve until no more air
escapes.