Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Tensioning the belt with V-belt drive
(Fig. 10 + 11)
To tension the V-belt, loosen the hex screws
("M"; Fig. 11), including the hex screws on the
opposite side (total 8 pieces).
Now tighten the hex nut ("N"; Fig. 12).
To check the belt tension, unscrew the cover
found on the side of the drive cover. Now press
with the thumb on the tensioned belt; under
strong pressure, it may give only approx. 10-15
To resolve problems, switch off the machine. Pull the plug!
Error
Saw doesn´t stop when
switched off
Electrical maintance work may be done only
by a qualified electrician!
Various saw blades (see scheppach catalogue)
Drive mechanism ........................................................................................................................ 15360701
3-point attachment ..................................................................................................................... 15360702
Old devices must not be disposed of with
household waste!
This symbol indicates that this product
must not be disposed of together with do-
D GB
mestic waste in compliance with the Di-
rective (2012/19/EU) pertaining to waste
electrical and electronic equipment (WEEE).
This product must be disposed of at a designat-
mm.
Now remount the cover and retighten the hex
screws ("N", Fig. 11).
Lubricating points (Fig.15)
Regularly lubricate all moving parts of your rock-
er circular saw.
All pivot points on the hinged shield (Fig.15, „R")
should be lubricated to ensure the ease of move-
ment.
Possible cause
Mechanical brake defective
Brake board defective
When disposing of the machine, observe the lo-
cal regulations
Separate accessories
ed collection point. This can occur, for example,
by handing it in at an authorised collecting point
for the recycling of waste electrical and electron-
ic equipment. Improper handling of waste equip-
ment may have negative consequences for the
environment and human health due to potential-
ly hazardous substances that are often con-
tained in electrical and electronic equipment. By
Troubleshooting
Solution
Replace brake
Replace brake board
18
Service information
Please note that the following parts of this prod-
uct are subject to normal or natural wear and that
the following parts are therefore also required for
use as consumables.
Wear parts*: Saw blade, rocker insert
* Not necessarily included in the scope of deliv-
ery!
properly disposing of this product, you are also
contributing to the effective use of natural re-
sources. You can obtain information on collec-
tion points for waste equipment from your mu-
nicipal administration, public waste disposal
authority, an authorised body for the disposal of
waste electrical and electronic equipment or
your waste disposal company.
Werbung
