Troubleshooting; Possible Cause - Scheppach 5901320915 Originalbetriebsanleitung

Do not throw old equipment away with household
waste!
This symbol indicates that this product must
not be disposed of in household waste as per
Waste Electrical and Electronic Equipment di-
rective (2012/19/EU) and national laws.
This product must be handed over at the intended col-
lection point. This can be done, for example, by return-
ing it when purchasing a similar product or delivering it
to an authorised collection point for the recycling of old
electrical and electronic devices. Improper handling of
old devices can have negative effects on the environ-
ment and on human health due to potential hazardous
materials which are often contained in old electrical
and electronic devices. By disposing of this product
properly, you are also contributing to the effective
use of natural resources. Information about collection
points for old devices can be found at your municipal
authority, the local disposal provider, an authorised lo-
cation for the disposal of old electrical and electronic
devices or your waste collection service.

19. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event of your machine failing to work
properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Saw blade is loose after the
motor is switched off
Motor does not start
Motor not supplying power,
fuse tripping
Burnt areas on the cutting
surface
Incorrect motor rotational
direction
 www.scheppach.com /  service@scheppach.com /  +800 4002 4002

Possible cause

Fixing nut not tight enough
Mains fuse blown
Extension cable defective
Connection to the motor or switch
not OK
Motor or switch faulty
Cross section of the extension
cable insufficient
Overload due to blunt saw blade
Blunt saw blade
Incorrect saw blade
Capacitor defective
Incorrect connection
Remedy
Tighten fixing nut, right-hand thread
Check mains fuse
Replace the extension cable
Have this checked by an electrician
Have this checked by an electrician
see "Electrical connection"
Replacing the saw blade
Sharpen saw blade (only by an authorised
sharpening service) or replace
Replace saw blade
Have this checked by an electrician
Have an electrician transpose the wall plug
poles
GB | 45