Troubleshooting; Possible Cause - Scheppach HS510 Original Bedienungsanleitung

13. Replace the saw blade and flange and tighten the
flange nut.
14. Reassemble the device in reverse order.
15. Test the functionality of the rocker.
ATTENTION ! Observe the correct direction of rota-
tion when inserting the saw blade.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Machine data - type plate
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use
as consumables.
Wear parts*: sawblade, rocker inlet
* Not necessarily included in the scope of delivery!

15. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Problem
Saw blade gets loose after
turning off the motor
Motor does not start
Wrong rotational direction
No motor output, turns off
automatically
Burns on the cutting surface
24 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

Possible cause

Fastening nut tightened insufficient-
ly
Failure main fuse
Extension cable defect
Connections on the motor or
switch defect
Motor or switch defect
Capacitor defect
Changed phase
Cross section of extension cable is
too low
Overload by dull saw blade
Dull saw blade
Wrong saw blade
Help
Tighten fastening nut, M20 left-handed thread
Check the mains fuse.
Replace the extension cable
Have it checked by an electrician
Have it checked by an electrician
Have it checked by an electrician
Have the polarity of the wall socket changed by
an electrician
See "electric connection"
Insert a sharpened saw blade
Insert a sharpened saw blade
Insert correct saw blade