Troubleshooting; Possible Cause - Scheppach HS110 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

18. Troubleshooting

Fault

Possible cause

1. Blade dissolves To slightly tightened fastening nut Tighten the right hand thread nut
after switching
off the engine
2. Engine will not a) Failure mains fuse
start
b) Defective extension cable
c) Connections on motor or switch
not in order
d) Motor or switch faulty
3. Motor wrong a) Capacitor faulty
direction of rota-
b) Wrong connection
tion
4. Motor will not a) Cross section of the extension
work, the fuse is cable does not suficiently
activ
b) Overload by a blunt saw
blade
5. Fire marks on a) blunt saw blade
the cutting
b) wrong saw blade
surface
40 GB/IE/NI
Possible cause
a) Check mains fuse
b) Replace extension cord
c) Repair by electrical specialist
d) Repair by electrical specialist
a) Repair by electrical specialist
b) Exchange polarity of outlet by an qualiied
electrician
a) see „Electrical connection"
b) Change saw blade
a) Sharpen or change saw blade
b) Change saw blade