Toro Tempus Pro Controller 4 Bedienungsanleitung Seite 15

Setting Program Start Time
(single irrigation cycle mode)
The program start time is the time of day you select to begin an automatic watering
program cycle. When a program starts, each station with a designated run time
duration in the program will operate in numerical order, one station at a time.
Sometimes it is necessary to run a watering program more than once per day: for
example, when watering a new lawn.
The Tempus Pro Controller provides 6 independent start times per day for each
program.
1. Turn the Programming Dial to the Start Time position
2. Press P+ or P- buttons to select the desired program A, B, C or D. Program letter
A, B, C or D will be displayed.
3. Press either the or button to select the desired Start Time number: 1, 2, 3,
4, 5 or 6.
4. Press either the or button to set the Start Time.
5. Repeat steps 3 and 4 for each Start Time number, as needed.
• To remove a Start Time from the program set it to OFF by decreasing the Start Time
below 12:00AM (0:00) or increasing it above 11:59PM (23:59).
6. Repeat steps 2–5 for each program as needed.
7. Press the Auto button when finished.
Setting Program Start/Stop Time
(Loop mode)
Sometimes it is necessary to run a watering program continuously between a Start
and a Stop time.
Tempus Pro Controller allow watering programs to loop continuously if LOOP MODE is
selected for the program. In addition it is possible to set a time delay (LOOP DELAY)
between the end of a watering program and the start of the subsequent watering
program.
The last watering program of the loop is the one that ends after the Stop Time.
Note: LOOP MODE settings apply only to a Program set to work in LOOP MODE.
. 1. Turn the Programming Dial to the Start Time position
2. Press P+ or P- buttons to select the desired program A, B, C or D.
Program letter A, B, C or D will be displayed.
3. Press either the
4. Press either the
5. Press either the
6. Press either the
7. Press either the
8. Press either the
9. To remove the Start Time from the program set it to OFF by decreasing the Start
Time below 12:00AM (0:00) or increasing it above 11:59PM (23:59).
10. Repeat steps 2–8 for each program set in LOOP MODE as needed.
11. Press the Auto
Important Note: if the Start Time is not OFF and the Stop Time is OFF, the program
set to run in Loop Mode will run forever.
Tempus Pro Controller 4-8-12-16
.
or button to select Start Time.
or button to set the Start Time.
or button to select LOOP STOP.
or button to set the Stop Time.
or button to select LOOP DELAY.
or button to set the Loop Delay.
button when finished.
15