Toro Tempus Pro Controller 4 Bedienungsanleitung Seite 13

Note: If LOOP MODE in Settings has been set for a specific Program, check Loop Mode
Box and indicate:
• the time of day to start the program the first time;
• the time of day to stop running the program continuously;
• the optional delay between two consecutive program irrigation cycles.
• Water Budget – indicates the percentage to decrease or increase the run time
duration currently set for each station assigned to a selected program.
About the Tempus Pro
Controller Memory
When not powered due to power outages or when the Control Module has been
removed from its Back Module, the Tempus Pro Controller:
• permanently retains the programmed watering schedule;
• keeps the clock active for the Back up time (up to 24 hours).
Back up time
How long the time keeping lasts depends on:
• how long the back-up power has being fully charged by the 24V a.c. power.
30 min charge is enough for 1 hour back up time, while 3 days guarantees the
maximum back up time.
• The programming activities on the Control Module while not powered by the 24V
a.c.
Back-up power is fully discharged
When Tempus Pro Controller is powered again after the back-up power was fully
discharged, the controller will resume normal operation starting at the time the
power became fully discharged. Current date and time must be set.
This permanent memory feature enables your landscape to continue being watered
with your programmed watering schedule if a prolonged power outage occurs while
you are away. Just set the current time and date and the Tempus Pro Controller is
ready to control your irrigation system automatically.
Note: after a long period without being powered or the first time the Tempus Pro
Controller is Powered with its Control Module installed, for best use allow 5 to 10
minutes for back-up power to charge itself before removing the Control Panel from
its Back Module.
Tempus Pro Controller 4-8-12-16
13