Toro Tempus Pro Controller 4 Bedienungsanleitung Seite 16

Tempus Pro Controller 4-8-12-16
Setting Station Run Time Duration
The station run time duration is the amount of time a station will operate once it has
been started.
A station is assigned to a program when it is given a designated run time duration
ranging from:
• 1min to 8h and 1min increment if TIME MODE in Settings has been set to H-MM
ONLY;
• 1sec to 7min and 59sec and 1sec increment, then 8min to 8h and 1min increment
if TIME MODE in Settings has been set to H-MM/MM-SS.
Each station can have a different run time duration in each program.
1. Turn the Programming Dial to the Run Time position
2. Press P+ or P- buttons to select the desired program A, B, C or D. Program letter
A, B, C or D will be displayed.
3. Press either the or buttons to select the desired Run Time number from 1
to the maximum number of stations of the Tempus Pro Controller model: 4, 8, 12
or 16.
Note: if a Tempus Pro 4-Station Module is missing, the number of stations available
is based on the position of the 4-Station Module to the right.
4. Press either the or button to set the run time.
• To remove the station from the program, decrease the run time duration to less
than 1 minute (or 1 second) to display OFF.
5. Repeat steps 3 and 4 for each Run Time number, if desired.
6. Repeat steps 2–5 for each program as needed.
7. Press the Auto button when finished.
16
Setting Water Budget
Water Budget enables you to conveniently decrease or increase the run time duration
currently set for each station assigned to a selected program. The adjustment can be
made in 10% increments from 0% (program Off) to 200% of the normal (100%) run
time.
Note: Water Budget can be applied to programs A, B, C and D independently. For
example, applying Water Budget to program A will not alter the run time duration
of any stations assigned to Program B, C or D.
Note: During operation, the display will show the adjusted run time for each station
as it starts running. As a reminder of Water Budget setting (other than 100%), the %
. symbol will be displayed.
1. Turn the Programming Dial to the Water Budget
2. Press
A, B, C or D will be displayed.
Note: if SEASONAL has been selected in SETTINGS, the percentage shown is the
factory pre-set value, the same for Program A, B, C and D. No manual adjustment is
allowed.
3. Press either the
i.e., 90% equals a 10% reduction of station run time and 200% doubles the station
run time.
4. Repeat steps 2 and 3 for each program as needed.
5. Press the Auto
or buttons to select the desired program A, B, C or D. Program letter
or button to select the desired adjustment percentage:
button when finished.
.