Shutdown And Storage; Maintenance Plan; Parts Subject To Wear And Tear - Solo 106 Gebrauchsanweisung

9.8 Shutdown and storage

For stops longer than three months the following work steps should be executed: Empty and
clean the fuel tank at a well ventilated location.
Start the motor with empty fuel tank run the engine until the carburetor is empty and the
motor shuts off. Otherwise the carburetor nozzles could become encrusted with fuel mix
residue and make a subsequent start more difficult.
Clean the motor device well (particularly the air intake openings, the cylinder heat sink
fins, the air filter and the tank duct area). Store the device at a dry clean and secure loca-
tion. There should be no open flame possibilities or similar in the vicinity. Prevent unau-
thorised use.
Generally keep children and youths away from this motorised equipment.

9.9 Maintenance plan

The following instructions are based on normal implementa-
tion conditions. For special conditions like strong dust accumu-
lation, or particularly long, daily working times, the specified
maintenance intervals should be shortened accordingly.
Carburetor
Air filters
Spark plug
Gearbox lubricant
(Modell 106)
Cooling air inlet
Cylinder head fins
Fuel tank
Fuel tank filter
All accessible screws (except
carburetor adjusting screws)
Cutting blade
(Modell 106B)
Grip
Total machine
Regularly execute the maintenance work. It may be necessary to a have a specialized workshop do this for you,
if you cannot do this work yourself. The device owner is also responsible for:
damages caused through non-specialized maintenance or maintenance not per
formed at the proper time.
Consequential damages - corrosion as well - in the case of improper storage.

10. Parts subject to wear and tear

Various parts are subject to application-specific wear or to normal wear and must be replaced in
good time if necessary. The following parts subject to wear and tear are not covered by the
manufacturer's guarantee: Air filter/ fuel filter/ all rubber parts that come into contact with fuel/
impeller and shredder blade/ anti-vibration parts/ sparkplugs/ collection sack/ starter fixture
34
check idle run
adjust idle run
clean
replace
adjust electrode gap
replace
check
top up
clean
clean
clean
replace
re-tighten
check
sharpen
replace
check for proper operating
inspect
clean
(1) = one
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X1)
X
X
X
X X